STLINK-V3SET Modular In-Circuit Debugger and Programmer

STMicro's faster and more flexible STLink probe eases STM8 and STM32 programming

STMicro's STLINK-V3SET Probe for MCUs STMicro's next-generation STLink-V3SET probe delivers enhanced flexibility and efficiency for debugging and programming microcontrollers. On top of JTAG/SWD/SWIM typical interfaces, a virtual com port and a multipath bridge allow the STLink-V3SET to communicate through the microcontroller UART, I²C, SPI, and CAN interfaces as well as GPIOs. This lets developers conveniently monitor run-time data on the host PC and simplify product maintenance with firmware update using a bootloader. With three times the performance and an intuitive drag-and-drop Flash memory programming, the STLink-V3SET helps users save development time and easily reprogram devices anywhere, on the bench or in the field.

Features

Stand-alone probe with modular extensions
Self-powered through a USB connector (Micro-B)
USB 2.0 high-speed compatible interface
Direct firmware update support (DFU)
Drag-and-drop Flash programming
Two color LEDs for communication and power
JTAG/serial wire debugging (SWD) specific features:

3 V to 3.6 V application voltage support and 5 V tolerant inputs
JTAG communication support
SWD and serial wire viewer (SWV) communication support
Flat cables STDC14 to MIPI10/STDC14/MIPI20 (connectors with 1.27 mm pitch)

SWIM specific features (only available with adapter board MB1440):

1.65 V to 5.5 V application voltage support
SWIM header (2.54 mm pitch)
SWIM low-speed and high-speed modes support

Multi-path bridge USB to SPI/UART/I²C/CAN/GPIOs specific features:

3 V to 3.6 V application voltage support and 5 V tolerant inputs
Signals available on adapter board only (MB1440)

Virtual COM port (VCP) specific features:

VCP frequency up to 15 MHz
Available on STDC14 debug connector (not available on MIPI10)
3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs